GCSE · Biology · AQA · Spec 8461

Required practical: light intensity and photosynthesis

Shine a lamp on pondweed and tiny bubbles rise off it. Move the lamp closer and they come faster. Catch those bubbles and you can measure how light controls photosynthesis.

The pondweed method, step by step

Every step is there for a reason. Open a step to see why, and how to stay safe while you do it.

  1. Final reading, then subtractWhen the three minutes are up, record the final volume of gas. Volume of gas produced = final volume − initial volume.

More light, faster photosynthesis… up to a point

036912036912Light intensity (relative)Rate of photosynthesis (relative)(6, 7.6)

Light intensity (relative): 6. Rate of photosynthesis (relative): 7.6

Exam line: On the rising part, light is the limiting factor. On the flat part (the plateau), another factor is limiting the rate.
Watch out: A flat line does not mean photosynthesis has stopped. The rate is still high. It just can't climb any further, because something else, such as carbon dioxide concentration or temperature, is now in short supply.

Planning the investigation

Changed, measured or kept the same?

Sort each variable in the pondweed investigation. Pick one, then pick the column it belongs in.

Still to sort

Independent variable (0)

The one thing you change on purpose.

Dependent variable (0)

What you measure to see the effect.

Where the line is: If it changes because of the lamp and you're recording it, it's dependent. If you're making sure it doesn't change, it's a control.

Control variables (0)

Kept the same, so only the light can be causing any change.

6 of 6 still to sort.

Turning readings into a rate

Fill in the missing steps

Illustrative results, lamp at 40 cm. The cylinder read 1.2 cm³ before the run and 7.8 cm³ after three minutes. Two repeat runs at 40 cm gave rates of 2.0 and 2.7 cm³/min. Find the rate for this run, then the mean rate at 40 cm.

  1. Volume of gas produced = final volume − initial volume
  2. missing step
Which line is step 2?

Evaluating the results

Which explanation would you sign?

A group's pondweed results are a bit wobbly. Five students each explain part of what's going on, using the words scientists use to evaluate an experiment.

Which one is right?
How sure are you?

Your turn to write

Hypothesis and improvements

A student is planning the pondweed investigation. (a) Write a hypothesis for the investigation, including a scientific reason. (b) Suggest two improvements to the method and say what each one improves. [4 marks]

0 words · your answer stays on this page and is not sent anywhere.

WHAT YOU'VE LEARNED

A quick recap of today's lesson.

How moving a lamp a few centimetres lets you measure how fast a plant photosynthesises, and why, at some point, more light stops helping.

What you need to know

  • Photosynthesis turns water and carbon dioxide into glucose and oxygen. Light isn't a reactant: it transfers the energy the reactions need.
  • A limiting factor is a condition that slows down or limits the rate of a reaction when it's in short supply.
  • With little or no light, photosynthesis is very slow or stops completely. Add more light and the rate goes up.
  • Have a goYour mate shuts some pondweed in a pitch-black cupboard 'to rest', with plenty of water and carbon dioxide. Will it give off lots of oxygen in there?

    No. Very little or none: with no light, photosynthesis is very slow or stops.

    Having the reactants isn't enough. Light transfers the energy the reactions need, so in the dark the rate drops to very low or zero.

  • Eventually the rate levels off (plateaus), because another factor, such as carbon dioxide concentration or temperature, is now limiting it.
  • Light intensity is how much light reaches a surface in a given time. Raise it with a brighter bulb or a closer lamp.
  • Have a goYour lamp is 100 cm from the pondweed. Give two ways to raise the light intensity reaching it.

    Move the lamp closer, or use a brighter bulb.

    Both get more light to the pondweed in the same time. Leaving the lamp on for longer doesn't count: light intensity is about how much light arrives in a given time, not how long you wait.

  • In the investigation, pondweed gives off oxygen into an upside-down, water-filled measuring cylinder while you time three minutes.
  • Change the light intensity (lamp distance), measure the volume of oxygen, and keep time, temperature, pondweed size and water volume the same.
  • Volume produced = final − initial volume. Rate = volume ÷ time in minutes. Mean = sum of readings ÷ number of readings.
  • Have a goA run starts at 0.5 cm³ and ends at 6.5 cm³ after 3 minutes. Work out the rate before you peek.

    2.0 cm³/min

    Subtract first: 6.5 − 0.5 = 6.0 cm³ produced, then 6.0 ÷ 3 = 2.0. Starting from 6.5 counts gas that was already in the cylinder.

  • Counting bubbles may be inaccurate, because bubbles vary in size. Collecting the gas measures its actual volume and reduces that error.
  • A hypothesis is a testable idea based on science you know; it doesn't have to be right. Matching results increase your confidence in it.

The big picture

You'll carry out and evaluate the pondweed investigation: change the light intensity by moving a lamp, collect the oxygen the pondweed gives off, work out rates and means, explain the pattern using light as a limiting factor, then hunt down the errors and fix them.

Key points

1Reactants: water and carbon dioxide. Products: glucose and oxygen. Light supplies the energy, so it's neither a reactant nor a product.
2Light is a limiting factor: as light intensity rises, the rate rises, until another factor limits it and the rate levels off.
3Move the lamp closer to raise the light intensity; collect the oxygen for a fixed time at each distance, and repeat each distance.
4Rate of photosynthesis here = volume of gas produced ÷ time in minutes; take a mean of the repeats at each distance.
5Varying bubble size is a random error; stray light from the room is a systematic error. Fix them by collecting the gas and using a dark room.

Worked example

Problem

Illustrative mean results from a pondweed investigation: lamp at 100 cm, 0.4 cm³/min; 80 cm, 0.6 cm³/min; 60 cm, 0.9 cm³/min; 40 cm, 1.4 cm³/min; 20 cm, 2.2 cm³/min. How should you plot these, and what do they show?

⚠ Watch out

Writing that light is a reactant in photosynthesis. The reactants are water and carbon dioxide. Light isn't used up as a reactant or made as a product: it transfers the energy the reactions need to take place.

🧠

Memory hook

Closer lamp, brighter light, more oxygen… until something else runs short. Then the maths: final minus initial, divide by minutes.

✓

Check yourself

Cover the page and talk through the method in order, from cutting the pondweed to the last repeat at 20 cm, saying why each step is there. Why does the funnel sit on plasticine?

Flashcards

(14)
What are the reactants and products of photosynthesis, and what does light do?
Reactants: water and carbon dioxide. Products: glucose and oxygen. Light transfers the energy needed for the reactions.
What is a limiting factor?
A condition that, when in short supply, slows down or limits the rate of a reaction.
Describe how the rate of photosynthesis changes as light intensity increases from zero.
Very low or zero at little or no light, then rising as light increases, until another factor limits it and the rate levels off.
What is light intensity, and how can you increase it in the pondweed investigation?
The amount of light reaching a surface in a given time. Move the lamp closer or use a brighter bulb.
How do you calculate the rate of photosynthesis in the pondweed investigation?
Volume of gas produced divided by the time in minutes.
Independent and dependent variables in the pondweed investigation?
Independent: light intensity, changed by the lamp's distance. Dependent: the volume of oxygen produced.
Give four control variables in the pondweed investigation.
Time the gas is collected for, temperature, mass or size of the pondweed, and volume of water.
Why is the funnel raised off the bottom of the beaker with plasticine?
So that carbon dioxide can mix throughout the water.
How could you show the gas from the pondweed is oxygen?
Put a glowing spill into it. If the gas is oxygen, the spill relights.
Hazard versus risk, using the lamp in this practical?
The hazard is electricity (something that may cause harm). The risk is the chance of an electric shock. Keeping electrics away from water reduces it.
Give three ways to stop the lamp's heat affecting the results.
Use a large beaker of water as a heat shield, use an LED lamp that doesn't get hot, or monitor the temperature with a thermometer or temperature probe.
Random error or systematic error: what's the difference?
Random: the size of the error is different each time (e.g. bubble size). Systematic: measurements are out by the same amount each time (e.g. extra light from the room).
Accuracy or precision?
Accuracy is being close to the true value. Precision is the spread of results around the mean.
Repeatable or reproducible?
Repeatable: similar results each time with the same method and equipment. Reproducible: similar results from another person, or a different method or equipment.

Tap any card to flip it, or use Study as deck to go through them one at a time. In the full lesson these run as a spaced-repetition deck — you rate each card Hard, Good or Easy and the tricky ones keep coming back until they stick.

Learning with Lightbulb is opening soon

You can use this lesson now. Join the waitlist and we'll let you know when the full Lightbulb experience is ready.

Keep me posted

More AQA GCSE Biology topics

See the full AQA Biology curriculum →

How this lesson was checked. This AQA GCSE Biology (specification 8461)lesson was published through Lightbulb Learning's human-designed editorial process — the educational standards, accuracy rules and publication checks it must pass were authored and approved by Philip Halpin. It passed subject-specific assessment, automated educational checks and technical publication verification before going live (publication checks completed 2 November 2026). Published pages are monitored, human spot-checking is ongoing across the lesson library, and anything found wrong is corrected or withdrawn. How our lessons are made and checked. Spotted a mistake? Email hello@lightbulblearning.co and we'll review it.

Helpful guides for parents and students