GCSE · Physics · AQA · Spec 8463

Reaction time

A hazard appears. Your brain has to notice it, think, and tell your foot what to do. That takes time, and the car does not wait.

How far does the car go while the driver reacts?

01234020406080Reaction time (s)Thinking distance (m)20 mThinking distance at a reaction time of 2 sdrag me up for a faster car
Speed 10 m/s

Speed: 10 m/s. Thinking distance at a reaction time of 2 s: 20 m

That distance is the thinking distance. Each line is for one speed (practice speeds). Set 20 m/s and read the line at 1 s and at 2 s, then change the speed and watch the line.

What happens between seeing the hazard and slowing down

Open any stage that has more to say.

  1. Notice the hazardReaction time starts when the driver notices the hazard. That is only the first part of it.
  2. Think how to reactNext the driver thinks about how to react to it.

Physics · Reaction time

What is the car up to?

A car is travelling along a road. The driver has just noticed a hazard ahead and is still reacting to it.

Which of these is closest to what you think is happening to the car?
How sure are you?

Worked example: from a speed limit to a thinking distance

Problem

A driver is travelling at 30 miles per hour. Their reaction time is 1.0 s (a made-up practice value). How far does the car travel before the driver starts to slow it down?

Physics · Reaction time

Which way can it push your reaction time?

Pick a factor, then pick where it belongs.

Still to sort

Can increase reaction time (0)

Reaction time can get longer.

Where the line is: A longer reaction time means a longer thinking distance at the same speed.

Can reduce it, or tends to go with better times (0)

Reaction time can get shorter, or tends to be better.

Where the line is: A shorter reaction time means a shorter thinking distance at the same speed.

7 of 7 still to sort.

Concentration matters too. One driving illustration has reaction times between 0.5 s and 1.5 s, towards the lower end if the driver is fully concentrating and at the higher end, or even beyond, if not. It is an illustration, not a figure to memorise.

Physics · Measuring reaction time

Run the ruler drop test

Put the steps of the ruler drop test in the order you would do them.

1 · First6 · Last
  1. Take the mean of the readings and use it as the person's reaction time

  2. The other person catches the ruler between their fingers as quickly as possible

  3. Set up: one person holds the ruler vertically with its timing strip, and the other holds an open hand with the start line level with the top of the hand

  4. Read the reaction time off the strip at the position where the ruler was caught

    The strip is a scale of timing markings, so the time is read directly.

  5. Repeat the test several times

  6. Drop the ruler without warning

WHAT YOU'VE LEARNED

A quick recap of today's lesson.

The car does not wait while you react.

What you need to know

  • For driving, reaction time is the time between noticing a hazard and taking an action to deal with it.
  • It has three parts: notice the hazard, think how to react, start to act (foot from accelerator to brake, then push).
  • Have a goA driver has just spotted a ball rolling into the road and is working out whether to brake. Which of the three parts is happening right now?

    Thinking about how to react.

    Noticing has already happened, and starting to act (moving the foot to the brake) only comes after the thinking.

  • In that time the brakes haven't been pressed, so the car doesn't slow down. It travels at a constant speed.
  • The distance covered while the driver reacts, before the car starts to slow, is the thinking distance.
  • Thinking distance = speed × reaction time. Rearrange the speed equation, and use metres per second and seconds.
  • Have a goMade-up numbers: a car is moving at 8 m/s and the driver's reaction time is 1.5 s. How far does it travel before the driver starts to slow it?

    12 m.

    Thinking distance is speed × reaction time, so 8 × 1.5 = 12. Dividing 8 by 1.5 is the tempting slip, but that is not speed times time.

  • Thinking distance is directly proportional to reaction time and to speed. Double either one and it doubles.
  • Have a goYour mate says: "I'll drive twice as fast, but my reaction time is the same, so my thinking distance won't change." Confidently wrong. What really happens?

    The thinking distance doubles.

    Thinking distance is directly proportional to speed, so double the speed doubles it, even when the reaction time stays the same.

  • Speed limits come in miles per hour, so convert: one mile per hour is 0.447 metres per second.
  • Tiredness, alcohol, some drugs (including some cold and cough medicines) and distractions like a phone can all increase reaction time.
  • Training can help reduce reaction times, and they tend to be better for people who drive more or drive professionally.
  • A ruler drop test measures reaction time. Repeat it several times and use the mean of the readings.

The big picture

A driver's reaction time is the time between noticing a hazard and taking an action to deal with it. It has three parts: noticing, thinking about how to react, and starting to act. The brakes have not been pressed during it, so the car travels at a constant speed and covers the thinking distance. Thinking distance = speed × reaction time, in metres per second and seconds, and it is directly proportional to both. Tiredness, alcohol, some drugs and distractions can increase reaction time, and training can help reduce it. A ruler drop test measures reaction time: repeat it several times and use the mean.

Key points

1Reaction time is the time between noticing a hazard and taking an action to deal with it, in three parts: notice, think, start to act.
2The brakes aren't pressed during reaction time, so the car travels at a constant speed and covers the thinking distance.
3Thinking distance = speed × reaction time, with speed in metres per second and reaction time in seconds.
4Thinking distance is directly proportional to reaction time and to speed. Convert mph with 1 mile per hour = 0.447 metres per second.
5A ruler drop test measures reaction time, and its readings are much smaller than driving ones because the person concentrates on one thing.

Worked example

Problem

A student does a ruler drop test three times and reads 0.14 s, 0.18 s and 0.16 s (made-up practice readings). Her reaction time is the mean of her readings. Use it to estimate the thinking distance for a car travelling at 20 m/s.

⚠ Watch out

Thinking the car slows as soon as the driver notices the hazard, or that reaction time is only the moment the foot moves. It has three parts, and the brakes are not pressed during it, so the car carries on at a constant speed.

🧠

Memory hook

The car doesn't know you've noticed. Until the brakes go on it keeps its speed, so thinking distance = speed × reaction time.

✓

Check yourself

A tired driver and a fully concentrating driver are travelling at the same speed. Whose thinking distance can be longer, and why?

Flashcards

(12)
What is a driver's reaction time?
The time between noticing a hazard and taking an action to deal with it.
What are the three parts of reaction time?
Noticing the hazard, thinking about how to react, and starting to act (for example moving a foot from the accelerator to the brake and pushing down).
What does the car do while the driver is reacting, and why?
It travels at a constant speed, because the brakes have not been pressed yet.
What is the thinking distance?
The distance a vehicle travels while the driver reacts, before the vehicle starts to slow.
How do you find thinking distance?
Thinking distance = speed × reaction time, with speed in metres per second and reaction time in seconds.
Thinking distance is directly proportional to which two quantities?
Reaction time and speed. Doubling either one doubles the thinking distance.
How do you change miles per hour into metres per second?
One mile per hour is 0.447 metres per second, so multiply by 0.447.
Name factors that can increase a driver's reaction time.
Tiredness, alcohol, drugs (including some cold and cough medicines that make a person feel tired), and distractions such as using a phone.
What can help reduce reaction times, or tends to go with better ones?
Training can help reduce them. They tend to be better for people who drive more or drive professionally.
In the ruler drop test, how is the reaction time found?
It is read directly off the timing strip at the position where the ruler was caught.
What is done with the readings from repeated ruler drop tests?
The mean of the readings is used as the person's reaction time.
Why are drop test reaction times much smaller than driving ones?
The person concentrates on one thing, whereas a driver concentrates on many things at once.

Tap any card to flip it, or use Study as deck to go through them one at a time. In the full lesson these run as a spaced-repetition deck — you rate each card Hard, Good or Easy and the tricky ones keep coming back until they stick.

Learning with Lightbulb is opening soon

You can use this lesson now. Join the waitlist and we'll let you know when the full Lightbulb experience is ready.

Keep me posted

More AQA GCSE Physics topics

See the full AQA Physics curriculum →

How this lesson was checked. This AQA GCSE Physics (specification 8463)lesson was published through Lightbulb Learning's human-designed editorial process — the educational standards, accuracy rules and publication checks it must pass were authored and approved by Philip Halpin. It passed subject-specific assessment, automated educational checks and technical publication verification before going live (publication checks completed 13 November 2026). Published pages are monitored, human spot-checking is ongoing across the lesson library, and anything found wrong is corrected or withdrawn. How our lessons are made and checked. Spotted a mistake? Email hello@lightbulblearning.co and we'll review it.

Helpful guides for parents and students