GCSE · Physics · AQA · Spec 8463

Electrical power (P = V I and P = I^2 R)

Send 1000 A down a typical 100 km power line and about 3 million watts leak out as heat. Halve the current: does the leak halve? Drag to find out.

Heating in a power line

0500100015002000036912Current in the line (A)Power dissipated by heating (MW)(1000, 3)

Current in the line (A): 1000. Power dissipated by heating (MW): 3

Slide along the curve: 500 A, 1000 A, 2000 A. What happens to the power each time the current doubles?

Watch out: The line is the same every time, so only the current changes. Double the current and the heating is four times bigger, not twice.

Two equations for power

P = I V and P = I² R

Power is how much energy is transferred every second. Multiply the current by the potential difference to get it; and in a resistance, the heating depends on the current squared.

P in watts (W), I in amps (A), V in volts (V), R in ohms (Ω). P = I V works for a whole circuit or any single component. P = I² R comes from putting V = I R into P = I V (P = I × I × R) and gives the power dissipated, the rate at which energy is transferred to the surroundings by heating.

Predict, then check

Your kitchen's mains circuit already has the kettle running. Now people keep plugging things into the same circuit.

More and more appliances are plugged into the same mains circuit. What happens to the circuit's current?

Physics · Plug fuses

Which fuse does it need?

Work out each appliance's normal current, then put it in the smallest fuse that is bigger than that current.

Still to sort

3 A fuse (0)

For a normal current below 3 A

Where the line is: If the normal current is 3 A or more, a 3 A fuse is too small: it would melt even in normal use.

5 A fuse (0)

For a normal current above 3 A but below 5 A

Where the line is: Bigger than 3 A, smaller than 5 A. Anything above 5 A needs the next size up.

13 A fuse (0)

For a normal current above 5 A (up to the biggest size)

Where the line is: Only when 5 A is too small. Never pick it just because it is the biggest.

5 of 5 still to sort.

Plug fuses usually come in 3 A, 5 A and 13 A. Pick the smallest rating that is bigger than the current the appliance draws when working normally.

Watch out: Find the current with P = I V at 230 V. Don't use P = I² R for this, and don't just pick the biggest fuse.

National Grid

?

Reason it through

Why does the National Grid send electricity along its lines at very high potential difference?

Link 1 of 3

First link · your turn

The Grid wants to send a fixed amount of power. P = I V. If the potential difference goes up, what must happen to the current?

2
Locked — reveal the link above first
3
Locked — reveal the link above first

Physics · Transmission losses

Finish the transmission-loss calculation

Three 80 km transmission lines each carry 800 A. Each line has a resistance of 3 Ω per 100 km. Find the total power dissipated by heating.

  1. The resistance is given per 100 km, and each line is 80 km, which is 0.8 of 100 km. So scale the 3 Ω.Shorter line, so less resistance.
  2. missing step
Which line is step 2?

WHAT YOU'VE LEARNED

A quick recap of today's lesson.

Electrical power, why fuses have sizes, and why the National Grid runs at very high voltage.

What you need to know

  • Power is the amount of energy transferred each second, and it is measured in watts (W).
  • One watt is one joule of energy transferred each second, and 1 kilowatt (kW) is 1000 watts.
  • At a constant potential difference, a larger current transfers energy more quickly than a smaller one.
  • For a whole circuit or any single component, power = current × potential difference: P = I V.
  • Have a goYour friend says a lamp with 3 A through it and 12 V across it transfers 4 W, because 12 ÷ 3 = 4. What is the real power?

    36 W (3 A × 12 V).

    Power is current times potential difference, so you multiply. Dividing the two finds something else, not the energy transferred each second.

  • UK mains appliances have 230 V across them, so a more powerful appliance draws a bigger current.
  • Have a goTwo appliances are plugged into the same 230 V mains. One draws 2 A and the other draws 8 A. Which has the higher power, and by how many times?

    The 8 A one, with 4 times the power.

    The potential difference is the same, so power goes up in proportion to current: four times the current is four times the power.

  • Too much current makes a circuit breaker switch the circuit off, or melts a thin fuse wire in a plug.
  • Pick a plug fuse (usually 3 A, 5 A or 13 A) as the smallest rating above the normal current from P = I V.
  • Put V = I R into P = I V and you get P = I² R, the power dissipated by heating in a resistance.
  • Because of the square, doubling the current through the same resistance makes four times the heating.
  • Have a goThe same line carries 100 A, then the current rises to 300 A. How many times bigger is the heating?

    9 times bigger.

    Heating goes with the square of the current, so tripling it gives 3 × 3 = 9 times the heating, not just 3 times.

  • The National Grid sends the same power at very high potential difference: a smaller current, so far less heating.

The big picture

Power is the energy transferred each second, in watts: P = I V for any circuit or component. UK mains gives 230 V, so more powerful appliances draw more current, and a plug fuse is the smallest rating above that normal current. A circuit breaker switches off an overloaded circuit; a short circuit lets a very large current flow. P = I² R gives the heating in a resistance, so heating goes with current squared, which is why the National Grid uses very high voltage.

Key points

1Power is the energy transferred each second: 1 W = 1 J/s, and 1 kW = 1000 W.
2P = I V works for a whole circuit or any single component, in watts, amps and volts.
3Mains appliances have 230 V across them and are in parallel, so more power means more current. I = P ÷ V finds it.
4A circuit breaker or a plug fuse breaks the circuit if the current gets too large; a short circuit has very little resistance and lets a very large current flow.
5Choose the smallest fuse rating (usually 3 A, 5 A or 13 A) above the current from P = I V at 230 V.
6P = I² R is the power dissipated by heating in a resistance, so heating goes with the square of the current.
7Higher transmission potential difference means a smaller current for the same power, and far less heating in the lines.

Worked example

Problem

A 1500 W kettle is plugged into the 230 V mains. What current does it draw?

⚠ Watch out

Thinking doubling the current only doubles the heating. It quadruples it, because P = I² R squares the current. And find a fuse with P = I V at 230 V, not P = I² R, then take the smallest rating above it, not the biggest.

🧠

Memory hook

Halve the current, quarter the heat: the I in I² R is squared. And for fuses: P = I V, then the smallest size above.

✓

Check yourself

Cover the page. A cable gets 40 W of heating at 5 A. At 10 A, what is the heating, and why isn't it 80 W? Why does the Grid use high voltage?

Flashcards

(14)
What is power?
The amount of energy transferred each second.
What is one watt?
One joule of energy transferred each second (1 W = 1 J/s).
How many watts are in 1 kilowatt (kW)?
1000 W.
What equation links power, current and potential difference, and what are the units?
power = current × potential difference, P = I V. Power in watts (W), current in amps (A), potential difference in volts (V).
At a constant potential difference, what does a larger current mean for energy transfer?
Energy is transferred more quickly.
What is the potential difference across UK domestic mains appliances?
230 V (the UK domestic value).
Two mains appliances of different power share a circuit. What is the same and what is different?
The potential difference is the same (230 V, because mains circuits are in parallel). The currents are different: the more powerful one draws more.
What does a circuit breaker do?
It switches the circuit off if the current exceeds its rating, so nothing gets hot enough to melt wires or start a fire.
What is a short circuit, and why is it dangerous?
A path with very little resistance. A very large current flows, so at 230 V a large power causes heating that could start a fire.
What is inside a plug fuse, and what does it do?
A thin wire that melts, breaking the circuit, if the current becomes too large.
How do you choose the fuse for an appliance?
Find its normal current from I = P ÷ 230 V, then pick the smallest available rating greater than that current.
Where does P = I² R come from, and what does it give?
Combine P = I V with V = I R to get P = I × I × R. It gives the power dissipated: the rate of energy transfer to the surroundings by heating in a resistance.
About how much resistance does a National Grid transmission line have?
Very little: about 3 ohms per 100 km. Scale it to the length of the line.
Why does the National Grid transmit at very high potential difference?
The same power then needs a smaller current (P = I V), and because heating depends on the square of the current (I² R), the heating of the lines is greatly reduced.

Tap any card to flip it, or use Study as deck to go through them one at a time. In the full lesson these run as a spaced-repetition deck — you rate each card Hard, Good or Easy and the tricky ones keep coming back until they stick.

Learning with Lightbulb is opening soon

You can use this lesson now. Join the waitlist and we'll let you know when the full Lightbulb experience is ready.

Keep me posted

More AQA GCSE Physics topics

See the full AQA Physics curriculum →

How this lesson was checked. This AQA GCSE Physics (specification 8463)lesson was published through Lightbulb Learning's human-designed editorial process — the educational standards, accuracy rules and publication checks it must pass were authored and approved by Philip Halpin. It passed subject-specific assessment, automated educational checks and technical publication verification before going live (publication checks completed 5 November 2026). Published pages are monitored, human spot-checking is ongoing across the lesson library, and anything found wrong is corrected or withdrawn. How our lessons are made and checked. Spotted a mistake? Email hello@lightbulblearning.co and we'll review it.

Helpful guides for parents and students